Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to generate a report of users connected to (and disconnected) the whole network with the AP detail and time ranges. We are trying to get a user count within some areas where Meraki APs are - so if we get this data, we can generate some...
So basically my colleague set this up as a small Meraki setup for an open internet. I was checking it remotely today and noticed- Internet port is configured as manual - Given an IP and gateway is set as the ISP ADSL Router IP (LAN port of ADSL modem...
Yes absolutely - the connection between MX and c9300 has the issue. And strangely, the setup is working fine with 100mb, if I change the port setting from auto to 1000 speed in c9300, it breaks. Same applies if I change the port settings in Meraki MX...
