Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone -I was practicing bgp neighbor form status with packet tracer, and I shut the peer interface after they established to with the peer.However the sh ip bgp neighbors output still shows established neighbor as 1. I am using a version 8....
Hello community;I am getting on my switches c9500 logs 3 - 5 log error message saying " currently power supply ( interface xxx supply voltage sensor ) status unavailable error logged. it reset the status to ok, after 15 min in all my devices. all in...
Hello Cisco community, I have a situation where I configured the end windows node with dual ip address and as a result the switch connected to the node has two IP arp entries for a single mac address. when this node make an outbound connection, I w...
Hi Everyone,
I am in the process of setting up ASA for home lab . In the process have attempted to configure inspection of icmp traffic and was following a doucument I got online. At a point, when enter
class-map type inspe...
Hello Everyone,
I am preparing for the CCNA security certification and bought used ASA 55xx. As a part of this effort I wanted to upgrade the ASA and use ASDM for configuration and administration. However I am getting service contract required messag...
I think this one is completely the PT limitation and is also inconsistence output above. Even though BGP uses TCP , after hold timer expires , the adjacency state expected to show the actual status. May be resetting the bgp process would speed up.....
@Flavio Miranda -thanks for your response. the topology is simple two neighboring routers connecting . I think the issue could be with the packet tracer limitation. After I reloaded the router the connection state still showed Established while the ...
I three of the interfaces triggering the alert they have the same SFP type TeX/Y/Z MMMMMMMMMMMMMMM connected trunk full 10G SFP-10GBase-LRTea/b/c GGGGGGGGGGGGGGGG- connected trunk full 10G SFP-10GBase-LR------------Port Name Status Vlan Duplex Speed...
Thanks for your suggestion.I looked the bug, but do not think it fully applies to my case because at some point the the sensor logs a status ok. It seems to me at that point the voltage sensor is working.Also my switch is 9500.
