Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
IntroductionCatalyst 2960-X and 2960-XR Switches Overview, Configuration, and TroubleshootingRelated Information Introduction FeaturedSpeakers Roopa R. is a Technical Leader in Enterprise Access Switching group at Cisco. She is an expert on For...
This is the recording of the webcast The Cisco Catalyst 2960-X models provide Layer 2 switching and have one fixed power supply with an external redundant power supply. They provide 24 or 48 Gigabit Ethernet wire rate ports, PoE/PoE+ support, and fou...
This document contains the slides for the Webcast.
The Cisco Catalyst 2960-X models provide Layer 2 switching and have one fixed power supply with an external redundant power supply. They provide 24 or 48 Gigabit Ethernet wire rate ports, P...
Please check the 3750 Datasheet for the NIMs supported with a particular SKU - https://www.cisco.com/c/en_in/products/collateral/switches/catalyst-3750-series-switches/product_data_sheet0900aecd80371991.html
Thanks,
Roopa
Not sure which image you are using on the 2960X. Can you please load 15.2(2)E8 and check if you see the issue? I think it is a known issue.
Thanks,
Roopa
