Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I confess, I'm a complete newbie as far as our C160 goes. We had one in here months ago as a trial for outbound DLP. When we were finished with it, since it takes months to get $$$ approved sometimes, I saved off the configuration. I've now loaded...
On a 2514 with 11.2 IOS, I'm trying to implement multiple ACL's to block all access to about 55 host addresses. I cannot seem to put them all into one ACL. When I do, the list just disappears, and I'm unclear on how properly to setup multiple lists ...
On a 2514 with 11.2 IOS, I'm trying to implement multiple ACL's to block all access to about 55 host addresses. I cannot seem to put them all into one ACL, or the list just disappears, and I'm unclear on how properly to setup multiple lists of about...
Can anyone point me to a listing of the meanins of the flags I see when doing a "sho conn" command? I'm trying to track down the significance of "saA" on an outbound ftp connection that is suddenly not working.I bought the "Cisco Secure PIX Firewall...
I've partially solved the problem. It turns out a setting I found in the IP knowledgebase was incorrect. I needed to set the C160 as the smart host on the SMTP connectors, not on the virtual servers.Now the issue is that although most mail is being...
Thanks for the clarification on the relay. Hadn't realized the setting is for inbound traffic.After each attempt, I've been restarting both the Exchange Routing service and the SMTP server service. I'm thinking it is probably an issue with the sma...
Thanks for the response, Andreas."No Changes Pending" is the status on the C160. After bringing the replacement C160 up to date on all system upgrades (it's running 7.1.3-010), I loaded the saved configuration that had been working. Both our email ...
