Buy or Renew
Buy or Renew
machiavelli
Level 1
Level 1
Member since ‎06-07-2005
‎08-18-2017
Awards
No awards available to display
Recent Badges

User Statistics

  • 13 Posts
  • 1 Solutions
  • 22 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
Reorder
5 Discussion Posts
10 Discussion Posts
1 Accepted Solution
5 Replies
Certifications
No certifications available to display

User Activity

Cisco Etherchannel

05-05-2009
Hi.Is it possible to create port channel (L3 interface bundling) between two L3 switches which ARE NOT directly connected? Both switches are connected with four interfaces to the L2 device, and those L2 devices are connected to two routers which are ...

port channel

05-04-2009
Is it possible to create port channel (L3 interface bundle) between two L3 switches (sw1 and sw2) which ARE NOT directly connected? sw1 - l2sw1 - l3sw1 - l3sw2 - l2sw2 - sw2

Line protocol is down

05-03-2007
Hi. Two of my company's routers, are connected with 2 serial connection with each other. No multi link interfaces are defined. Serial 0 works fine, but Serial 1, after issuing "no shut" command, works couple of seconds, and change it's state to "Seri...

Cisco 831 number of interfaces

01-08-2007
As I can see on it's backplane, I'm sure that Cisco 831 router has four 10/100 BASE-T RJ-45 interfaces (integrated switch) + one 10BASE-T RJ-45 interface (WAN ethernet port), but "show run" output shows two extra interfaces. "show ip int" output disp...

Cisco 831 CEF Problem

12-28-2006
Hi,I have problem to enable CEF on my Cisco 831 router (2Eth+4FastEth ports). As I can conclude, default IOS on it (12.3(2)XE3) supports CEF, but I have problem with enabling. When I type "IP CEF" in config mode, router stop responding for a few seco...
Community Statistics
Member Since ‎06-07-2005 11:49 PM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 13