Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear community,I am working with Cisco 1300 series switches and would like to configure RADIUS authentication and authorisation for SSH administration.RADIUS authentication is working correctly, but after login the user is assigned the minimum EXEC p...
Dear Community,we've been experiencing issue recently with our WiFi network. We've noticed some unexpected disconnections affecting our clients, and despite checking the channel utilization and radio profile, everything appears to be in order.Each ti...
Dear Community,I'm reaching out to seek some insights regarding an issue I'm experiencing with my network setup. I have two C9300 Meraki Mode switches in a stack, running on CS 17.2.3 software. These switches are configured as core switches with rout...
Dear Community,I am currently facing some confusion regarding the configuration of the VRRP mode on two C9300 IOS-XE 17.18.2switches that are cloud-native and connected by a fiber link.Here is my current setup: I have designated one of the C9300 swit...
Dear Community,I've organization with two networks with only MX installed (no Switch, no Access Point ecc.). The inventory is correctly list only the MXs.On the Organization -> Firmware upgrade menu the system report criticals for: Wireless, Cellula...
Hi, On this software, the command “aaa new-model” is not available, and the other two commands can only be configured without the group option: aaa authentication login default radius local aaa authentication enable default radius enable However, th...
Yes, I have tested VRRP failover with C9300 switches in a live production environment, and everything worked as expected.
It's important to have the necessary default routes configured on both core switches, similar to classic VRRP setups. Also, make...
Hello,
I didn’t configure VRRP via CLI—my configuration was done entirely through the dashboard. Initially, I ran into a bug where the dashboard didn’t display the configurations
Today I double-checked the settings and found that Cisco seems to h...
Dear community,
We’ve encountered the same issue on another new infrastructure that includes CW9172I and CW9163E access points running firmware MR 32.1.6. The logs are almost identical to what we observed previously. Notably, this time the WPA3 trans...
