Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,ISP on each circuit cannot provide more than 3MB, so soon will get three circuit each of 3MB. ISP recommends to terminate all the links on Layer2 switch and have a trunk to the Router. I need all experts opinion on this proposed setup. We cu...
HiI got 4500 Switch with 24 port Ethernet module 10/100/1000 and One SFP module. Port Gi 1/0/1 - 18 server's are connected. Two user switches 2960 is connected as a trunk to 4500.User VLAN 10Server VLAN 20SW1 - 2960 - user switchSW2 - 2960 - user sw...
HiJust a question "Can a password recovery possible on Cisco ASA models" condition having physical access to the box. Assuming password recovery is possible then what happens to the configuration on the box after recovery.cheersKeven
HiIs it doable to forward VLAN 4 over a WAN Link in my scenario.My requirement is to have one PC in S2 to be on VLAN 4 and use IP 192.168.4.25S1 -------------------- S2S1 connects to S2 over Private circuitOSPF is the routing protocol****************...
Hi Walter,ISP cannot provide all links in one public subnet and the links cannot be ppp as well. How it will differ if the three links are from different isp.I was also seeking config help in the forum to terminate 3 links on L2 switch and a trunk to...
Hi RickAll 3 GRE tunnel end will be at HQ, if one ISP is down still reachability is there.I need help on configuring three ISP on Layer2 Switch and trunking to a router.thanksKeven
Thanks RickWill only have Outlook Web Access Server to be accessed from outside to inside and for now we are not looking at redundancy for this service.The 3 GRE over IPSEC tunnels will connect to our HQ office. On LAN segment we got OSPF running in...
Peter Thanks again. Here are the details againS1--------------------------S2With Current configuration all Subnets on S2 is reachable via S1 and vice-versa.After I change the configuration on S1 and S2 tointerface GigabitEthernet1/1switchport trunk ...
Peter thanks for the input. We are group of companies and S1,S2 are Units of these groups.Both Sites are running in different VTP domains ; and changes to VTP domain is not possible.Not sure still this config is helpfulinterface GigabitEthernet1/1swi...
