About froweina1

froweina1 · 04-22-2010

I have a brand new router, 3825 and licensing so no worries there. I also have some discs Cisco Unified Communications Express Products and Cisco Unified Contact Center Express/ IP IVR.Question 1) I am trying to install CME (which I hear is now Unif...

froweina1 · 04-13-2010

I have a Cisco 3825 router with a switchport module NM-ESW-16. I am using the switchport as a L2 switch with no problems, with the fastethernet ports configured that way, can ping etc on that module. What I can not do is get out of that module, I h...

froweina1 · 04-13-2010

Ok so I pulled the HWIC-4 esw card out...and it works. Now I am completly lost. Why would the two cards plugged in not work if they are not configured or cabled together or anything?I think i am understanding it more after reading. What I am unders...

froweina1 · 04-13-2010

no there is a NM-CEM-4SER and a HWIC-4esw which neither are configured to my knowledge and there are no cabling between them.

froweina1 · 04-13-2010

what do you mean by network config, also the other router is not in the loop now. I am just trying to get from the switchport module on router A to router A.

Member Since	‎04-13-2010 07:17 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	5

User Statistics

User Activity

Cisco Unified Communications Express

3825 Router switchport module issue

Re: 3825 Router switchport module issue

Re: 3825 Router switchport module issue

Re: 3825 Router switchport module issue