Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am having an issue getting a local span session to work on a couple of my 3750's. I have a very basic requirement to span one port to another and wireshark the destination port to grab some traces. This is something I've done a thousand times ...
Hello,I wonder if you can help. I have setup a PEAP authenticated WLAN system using Cisco LWAPP / WLC with authentication being controlled through Windows 2003 IAS. All is working well but I want to make this setup more secure. At present non-domai...
Hi,I have some Nexus switches deployed in my network. They are authenticating user access via TACACS/ACS (4.2). I would like to get the user role part working as currently any users logging in get defaulted to a network-operator role so doen't have...
Hello,I have set up a Voice/UDP jitter IPSLA between a local router and a remote site on my network. The latency to the site is 250ms. All looks ok except that I get some starange results for Packet Loss of 80%. I know this isn't really the case e...
Hello,I am trying to build a tacacs+ config to roll out on my network devices. I have an ACS doing the authentication. What I would like to do is have the ACS authenticate my users and their enable access. However I would like to leave console acc...
Managed to get this working and it was all down to something to do with the laptops I was using. In dispair I tried a third newer laptop this morning running wireshark version 1.2.6 and all is working nicely......Thanks to those who replied.
Thanks Hobbe,"Both" is the default when you don't stick in Tx or Rx and you can see in my output that Both is selected. I even tried to include Both just for good measure but not that easy I;m afriad.Thanks for your reply though.
Hi Jiyon,Thanks for you quick reply. I was hoping it would be something like that but I tried configuring a monitor session 2 with a different source and destination interface and still have the same issue. RK
