Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've installed a new CSM and I'm trying to monitor it by SNMP.Could anyone tell me which MIB must I monitor in addition to: 'slbVirtualServerState' & 'slbRealState' ?Thanks.Nereida
Hi, I've a Cisco7600 with some 10/100/1000 cards.One of them has been reloaded by the Catalyst and appears the next message:%C6KPWR-SP-4-DISABLED: power to module in slot 12 set off (Fabric channel errors)What could be the cause or the faulty compone...
Hi,I've inserted a new card of 48 ports 10/100/1000 in a Cisco 7600.45 seconds after the new card passed the diagnostic and becomes up, I've receipt the next message from the Standby SLB: '%CSM_SLB-6-REDUNDANCY_INFO: Module 5 FT info: State Transitio...
You can try with extended ACL applied direction 'in' in the port in which the PC is connected.access-list 127 deny tcp any any eq 80access-list 127 permit ip any any interface fast0/5ip access-group 127 inRegards.
Hi, I've the card on line because a few minutes after this message, appears another indicating that the card is on.The question I have is:- what could cause this reload?I've an external syslog and there is no previous logs one hour prior to the resta...
Hi, I know that the message indicates a change in the status of the standby card. After this message, there is another indicating that this card return to standby state.In the moment that standby card became active, the active one realized that there...
