when I read cisco documentation , the documentation have a words :"!−−− You must enable process switching for IPsec !−−− to encrypt outgoing packets. ."example :interface Ethernet1ip address 10.1.4.1 255.255.255.0no ip route−cacheI have a test . The...
R1-----R5-----R3,R5 is frame-relay switch ,. R1 can not communite with R3, what is the wrong ,please ?R5interface Serial1/0 ###### to R1 no ip address encapsulation frame-relay serial restart-delay 0 frame-relay lmi-type cisco frame-relay intf-typ...
hello i has 5 routers ,1--2---3---4---5. 1 and 2 run bgp in as 12, 3 in bgp as23 , 3 and 4 run ospf , 4 and 5 run bgp in as 45.I redistribute bgp into ospf on 3, and use route-map of set tag automatic-tag. then I redistribute ospf i...
three router 1--2--3, all interfaces enable rsvp by using command "ip rsvp bandwidth ". loopback 0 of r1 has ip address 1.1.1.1 and loopback 0 of r3 has ip address 3.3.3.3. using command "ip rsvp sender-host 1.1.1.1 3.3.3.3 tcp 1 1 500" on r3 ; us...
three router 1--2--3, all interfaces enable rsvp by using command "ip rsvp bandwidth ". loopback 0 of r1 has ip address 1.1.1.1 and loopback 0 of r3 has ip address 3.3.3.3. using command "ip rsvp sender-host 1.1.1.1 3.3.3.3 tcp 1 1 500" on r3 ; us...
