Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Given several prompts to ChatGPT but wanted to check with the experts here too.We're a Meraki MR customer since 2013. I just decommissioned my 802.11ac MRs from 2015 (MR32, MR33, MR34, MR42, MR52) for new CW9164I models (40 total) and two CW9166D1 mo...
I'm at a loss. We're trying to allow client VPN access (Meraki auth) to a DMZ VLAN for our facilities network and HVAC contractors.One transit VLAN to our L3 Core MS 425; one DMZ VLAN for facilities BMSThe firewall rules look fine and should not affe...
We recently (with some help from a network consultant) created a DMZ for our facilities LAN by defining it on the MX 250, then adding a few firewall rules.Can we create a Client VPN that only allows access to that VLAN?
Using the full stack from Meraki.Meraki MR documentation for QoS says to make sure switchports that uplink MR APs respect inbound DSCP tagging from the APs.Is that a switchport setting (e.g. STP Guard or Trust DAI)? Or is it a QoS setting?
For example if I set a per-SSID bandwidth limit to 5 Mbps, does it do any good to also set a client limit?What are the best practices here?I have a business cable ISP WAN connection of 300/30
Sorry to reopen this thread, but I want to see if I understand how UDLD and STP guard should be set up on my topology. Here's the high level image from the dashboard. Very simple hub-spoke. Single uplinks from IDFs (either a stack of two or just a si...
