Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I am not sure why they say they can only change the gain, while [xConfiguration Audio Input Ethernet[1..8] Mode](https://roomos.cisco.com/xapi/Configuration.Audio.Input.Ethernet[1..8].Mode/) can mute the input fully. It will not change the LED c...
In the webinterface of the codec, there is a section called the "UI Extension editor" - that's where you design your buttons.For more info on this, go take a look at https://roomos.cisco.com/doc/TechDocs/UiExtensions
For reference, this site is full...
This particular macro was written for the EQ. If you want to do the same on the Codec Pro, you'll need to substitute Gain with Level, and adjust the default values. The rest should be the same.So in effect,
xapi.Config.Audio.Input.Microphone[2].Gain...
Short answer is "maybe, but we may need to go about this differently". The last bullet point in article you refer to states "Touch redirect is not supported".The longer answer is that even though using 3rd party touch screens with RoomOS devices (be ...
in MTR-mode, you can add custom buttons on the control panel (The panel you swipe in from right), but you're right, Cisco cannot change the Microsoft controlled UI inside the MTR application.When it comes to xAPIs, your source of knowledge is the bes...
