Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello TeamI added a primary MX95 into my Meraki dashboard and i would like to add a spare one.But I get this error message when i want to add the spare (HA mode is not supported on MX neetworks enabled for IPV6).How can i resolve this issue in order ...
Hi teamI need to configure a IKEV2 ipsec vpn tunnel between watchguard firebox and a Meraki MX95.All parameters are the same for phase 1 and 2 but the tunnel is not up.When i try to capture traffic no packets are detected.Do you think the watchguard ...
Hello teamI would like to enforce our DHCP security policy on our Meraki network.We have several MX and several MS.On a test site i blocked all IPv4 and IPv6 DHCP servers except my 2 MX firewalls (primary and backup) based on their mac adress.From wh...
Hello TeamNeed to purchase some performant wifi access point for my office.The office : 1 big open spaces on the first floor with 50 users using google meet visioconference on laptops.1 big open spaces on the second floor with 40 users using google m...
Hello Team,I am using a Mx 75 firewall on a location.The ISP provide to us a /29 subnet so i can use 4 different public IP address.I would like to know if it possible with Meraki to do this configuration : - For any port From a local device 1 to inte...
I can’t believe it either.I hope this change is implemented soon, as the list of GUIDs across my 90 Meraki networks is very, very long.How long will it take Cisco to implement these new priority options for names?Thank you
thanksI am an administrator of all the org. No forget button when i select a client from the network wide client list (only the edit policy button)....
