Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a single Firepower 1120 running ASA software which is currently in production and working fine. It has been decided to add a second 1120 and convert them into an HA pair running as active/standby for redundancy. Can anyone advise if there is...
HiI have a strange problem I have not come across before, where one end of a fibre connection shows as "connected" but the other end shows as "not connected".I have a C2960-48PST-L connected to a C3750X-12S-E via OM4 fibre. Both switches use GLC-SX-M...
We have a production stack of 3x 3850's but have run out of ports and need to add a 4th member; I followed the recommended procedure for adding a new member [Configure “software auto-upgrade enable” on the existing stack, rack the new switch but dont...
Hi,
We have 3850 switches at the access layer with L2 trunk uplinks to 6500 switches with Sup2T at the Distribution/Core layer. We have auto-qos enabled at both layers but I am unable to find the cos-dscp and dscp-cos mappings being used by these swi...
Hi
We run AutoQoS on our 3850 stacks, and on the old 3750's we used to be able to view the cos-dscp mapping table using "show mls qos maps cos-dscp", but there doesn't appear to be an equivalent command on the 3850. The nearest command seems to be "...
Thanks, I followed the guidelines and was able to convert the single unit into an HA pair.There was an outage of about 30secs after entering the "failover" command on the active unit whilst it negotiated with the new unit and then applied the active ...
No it had a default config straight out of the box - my understanding from the documentation is that when a new switch joins a stack it will have a default member number of 1, but during the process of joining the stack it will be assigned the lowest...
Hi Seb The stack and the new member are both running in install mode, however the stack is running version 3.06.04.E and the new member is running version 16.3.6
Hi Reza
Thanks for your reply, but this command doesn't show what I need. To confirm, I want to see the cos-dscp and dscp-cos mappings being used by the 3850's and 6500's.
In a 3750 this would look like this:
c3750#sh mls qos maps cos-dscp Cos-dscp...
