Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way to create a probe in the ACE that can telnet into a rserver login with a uid/pass and pass the probe when a expected return message is sent back from the rserver? I have been looking into way to do this for days. I thought I might be...
I have a 1760 router with a 4 port ethernet card. It has the Vlan1 int on it for f0/0 in the IOS. I need to apply an ACL to that interface/subnet with the phyical cable in f0/0 and ip range of vlan1. When appling the ACL should I apply it to the p...
I have a large network and a Access layer is 3750E's. I have 2 3750E's that are connected together on the backplain with the Backbone cable. These 2 switches are on a private section of my network (not accessable to anything other than the servers ...
I have 2 6504's with sup32 and a copper gig ports on the DFC. I have a Layer 2 connection between the 2 6504?s on the DFC. I have 2 servers one off each 6504 that need to talk to each other. So the packet flow should go?.Server A to 6504A to layer...
I have a router with a WAN connection to a RIP network, and I am redistributing RIP into BGP, I have a eBGP neighbor off my redistribution router. On my RIP route when it gets to my eBGP neighbor I get a metric set of 1 on my route. 10.133.160.0/2...
I figured out what happened, I am getting a best route Via iBGP, and in the redistribution into OSPF, my backup VPN routes in OSPF admin distance 110 are better, causing my sub-optimial routing.Thanks, this just took some time for me to think about.C...
Sundar,Thank you for the detail explanation and the links. After reading your post and going over the link on CCO it is all crystal clear now. I went back and re-read the Doyle information and it makes sense what he is saying now. Greatly appreci...
