Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Is there anyway to make an 1200 AP ask for a username / password (same for all devices) before a devices associates with it?I just need that security, no encryption afterwards.Sorry if this is too simple, but I'm new to wifi!!Thanks a lotFernan...
Hello, We are experiencing problems in some sites (Hotels) when the laptop that tries to use BBSM has a fixed ip address configured. No problems when it uses DHCP.Sometimes it works good but in most cases the BBSM welcome screen doesn't even appear a...
We've bought 2 3550 SMI's to replace our 3524Xls, our network consists just of the 2 switches (single VLan 10.164.99.0 /24, one host/server per port) a corporate Internet access (256kbps, internal ip 10.164.99.3) wich deals with the corporate traffic...
Hello, I need some help with this:Small network, 2 3524xl switches linked by 1 gbic(copper) adapter on each switch, single vlan (1) , simple configuration.about 10 days ago the network started to give many problems, after many tests (hardware is ok) ...
Thanks for your help,but does the 3550 SMI support PBR?Cisco says it doesn't.Would my simple static routes work? How would you improve them?Thanks again
Thanks all for your answers,seems that the GBIC adapter comes down and up without apparent reason. Already tried: -Change ports and GBIC adapters, hardware seems ok-Switchport mode trunk on both gbic ports (single vlan, that wouldn't be necessary ple...
Thanks for your answers,I've solved it! The problem was at the Layer3 device to which this switch is connected to.It's a 3550 Multilayer Switch. Somehow (if you have any clues about this please let me know) this switch lost some entries at its vlan d...
Thanks for your answers,In my case we use a router as the terminating device. I understand that succesfully connecting depends on each guest´s terminating device.If they use a VPN concentrator it could be solved configuring this device.If they use ...
If your cable modem supports multiple hosts (using it's internal dhcp server)you should just connect all the PC´s (NIC's using dhcp) and the cable modem to the switch. Use a cross-over cable for the cable modem and forget about Internet Connection S...
