Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, i would like to ask for your help.I am trying with my colleague configure HA for two MXs 105 with virtual IPs(3 public ip). Everything was working until our customer built second server room and we added second core switch to topology. Befor...
Hello Guys,we have SD-WAN scenario, where customer added a WEB server to spoke location and wants to access to this server via public IP on HUB and port 8080. All traffic is routing to the internet via HUB Public IP(one exit point to the internet for...
Hello guys,i would like to ask about your help. I am depolying sdwan customer with 18 sites and maybe in 11 sites are active cellular link. Cellular is primar active link and one cable link is for failover(cable is not my link). Everzthing seems to b...
Hello guys,i am going here for advice.I have a project where is planning MX75, 3Meraki switches and 19APs(MR28)....but this will be done in summer.Now i am trying to configure IPSK without radius and there is still some problems.My lab is(MR67 + MS12...
Hello guys,i would like to ask for a advice. I have more sites, where are strange RSTP logs and behavior. Network logs showing that more ports are RSTP affected. In three different location. I am 100% sure, that all 3 location are loop free(without l...
Hello, i had before stable version, but it looks very similar, therefore i did firmwere upgrade to stable candidate, because there was some bugfixes with IPSK. But my opinion is that is some problem with groups and AP. It should be very simple but so...
Yes, this is true, but not at full. If we are speaking about some uplink/downlink ports. Then logs are ok. But if we are speaking about Access port? Its normal behavior to have RSTP enabled on ports(by default). Yes, good practise is to have som secu...
