Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I have 7921s with firmware 1.1.1, connecting to 1000 series LAP and 4402 controller running 4.2.99.DHCP server is behind the controller on a 3560. Call manager is 5.1.When I configure my WLAN for 802.1X (I am using EAP-FAST), my authenticatio...
Well, 871W is 802.11bg only, while 1242 is ABG, so you have more wireless space on the 1242 if you configure the same SSID on both radios...But the 1242 is not a router obviously, just a layer 2 AP, so you will need a router then...30 to 35 users is ...
You know,DCA is enabled by default, and there are only 3 non-overlapping channels anyway. Your APs are better on channels 1,6 and 11, hearing the neighboring APs (and taking their signals into account to determine when to send and when to stay quiet...
Hi,2 points:- Rogue policies are available on the 526 just like on the Enterprise solution (Check under Security > Wireless Protection Policies > Rogue policies)... but it may depend on which version of the code you run. This feature is available fro...
Hi Tony,thanks for your rating and glad your problem was solved. I do not see any short document on this principle, but this is how it works:Speeds can be mandatory, supported or disabled."Mandatory" means that the client HAS to be able to support th...
It has to be a trunk, because the rogue detector is used to detect the ARP requests, so you need to connect it to a trunk so that all ARP requests from all VLANs are detected.Hope it helpsJeromePS: please also check in this forum, there were a couple...
