Hi, I'm having some difficulties setting up the switch, I can't figure out how to set up the Trunk port for the VLANs created. I have configured under VLAN Management, VLANs 10 and 20, I have asigned por...
Thanks to David S Hornstein, I've managed with his support to configure the VLANs and make two VLANs to multiplex (trunk port) through two gigabit uplink ports. Here's the configuration i made.I want to make 2 VLANs, Administration and Workgro...
Is there another way to configure this sw? like telnet or ssh to it or CLI ? or is there a better firmware for it like for the Linksys WRT54GL (dd-wrt firmware).
Yes, probably theat would work for the SRW, but i have to setup the CISCO SLM224G, and the problem is i don't have that "mode" option to setup "Trunk" or "Acces"...So... it leades to the next obviously question: the Cisco SLM224G doesn't ha...
Yes it makes sence what you say, I tryed to set it up like that but it doesn't work,e1,e2,e3,e4,e5,e6 Acceptable frame type = "Tagged"e7,e8,e9,e10,e11,e12 Acceptable frame type = "Tagged"e24 Acceptable frame t...
Hi, I have the same problem, I've got a Cisco SLM224G and I have created the VLANs, but can't figgure out how to setup the VLAN Trunk. I'm starting to believe that this switch does not support "Trunk" mode... so dissapointing , hope someone finds us...