Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I wonder if anyone can assist with an issue we are experiencing. We currently have two 6509E switches both running IOS version 12.2(17d)SXB10.We currently have an etherchannel between the switches made up of 3 x 1Gbps fibre links on a WS-X6748-SFP l...
I have a Cisco 877W (IOS version 12.4(15)T9) setup at an office which is used primarily for Internet access for the users. They have a requirement for remote workers to connect to resources sitting on the local LAN. I have configured the router so ...
I wonder if someone can assist with the solution I am looking to implement. We are having a new radio link which will connect one of our remote sites back to head office (Kensington). The radio links terminate at the remote end on a 1Gbps which is ...
Hi,I'm trying to back up the IOS image for our core 6509 switch using my workstation which is running the tftp server application. The issue I am having is that the image copies fine until it gets to the 32Mb mark and then begins to time out? When ...
Hicham,I don't think that will make any difference, I have come across issues where the speed and duplex settings needs to be hard coded and such issues show up as collisions and CRC errors and these tend to occur on switchports that support multiple...
Hicham,See below output as requested: -como6509sw01#sh int po4Port-channel4 is administratively down, line protocol is down (disabled) Hardware is EtherChannel, address is f866.f2f3.be11 (bia f866.f2f3.be11) Description: 20GBPS TRUNK TO COMO6509SW0...
Edward,We experienced the same issue with a 4506-E switch with a supervisor 6L-E in slot1 and WS-X4648-RJ45V+E in slots 2 and 3. The issue that we had was with a 7940 VOIP phone. It would not get power from module 2 but would work fine from module ...
Alex,Thnaks for the useful information. I have gone down the path of now implementing LACP across our infrastructure now and trying to move away from the propriotory PAgP.As you can see from the configuration of the 10Gbps links I have used active f...
Tihomir,Thanks you for your feedback. I currently have a NAS device which is sharing out a directory and I am not able to ping the NAS device. This does not have any form of firewall or security so I should be able to ping that?Any other suggestion...
