Hi All,I have a customer who has 2 sites which are 5 KM apart. He has only a plain telephone copper wire between these 2 office. He doesnot have any other media.He wants to connect these 2 offices via telephone wire. Can we use an ADSL router to achi...
Hi All,I have a situation where a customer wants to connect his office which are 5 KM apart and has a telephone line in between the offices. There is no other media in between the offices. I thought to use the 2950 LRE but it supports at max 5000 fee...
Hi All,I have a customer which has the following setup. R1 / \ R2 R3 \ / R4R1 is at the central site and has the data center hosted. The link between R1 and R2, R2 and R4 are in Are...
Hi All,I have a customer which has the following setup. R1 / \ R2 R3 \ / R4R1 is at the central site and has the data center hosted. The link between R1 and R2, R2 and R4 are in Are...
Hi All,I am new to voice technology and trying to learn the fundamentals of it. Please let me know, where to start from and all basic thing I should learn before going into IP telephony and all.Reply would be appreciated.regards,-amit singh
Hi,This module 6148A-Ge-TX has 2.67MB buffer per port.It is not shared with other ports.http://www.cisco.com/en/US/products/hw/switches/ps708/products_data_sheet0900aecd8017376e.htmlHTH,Please rate if it does.-amit singh
John,You can acheieve the same using time range with ACL's.Please find the link below for the same configuration.http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12235se/scg/swacl.htm#wp1035167-amit singh
Fabrice,The command in 12.4T11, is only supported on Etherswitch modules on ISR routers. Its is not supported on 877 router.The link above has this info.-amit singh
Thomas, what is the config-register setting on your router.Make sure that its is 0x2102.Check it in the rommon and chnage it if its not the same.-amit singh
Thomas, I think there is some problem with the IOS.May be this IOS is corrupt. I faced the same problem on my 1700 router today and I had to put in a new image on the router. Try tftp a file to the router using if "tftpdnld" option is available in ro...
