When prompted for user authentication, it won't accept the credentials though it is valid from the ACS database. But when the router is configured for local authentication it works. Can someone pls help
HI,my customer have purchased 2 units of pix firewall 535 with failover bundle. It comes with 6.34 but i've upgraded to 7.0. It seems to have more features that comes with it. However i'm really worried the stability of this new major release and als...
HI, we're in the middle of waiting for the Cisco VMS 2.3 and i have a few concerns:1) VMS has SSH sessions to all the devices being managed. Does these session stay up permanently or only when needed.2) From what i know VMS comes with Ciscoworks com...
Hi, i have a cat3550 which i've done a format on the flash. after doing so, i put in the image which is c3550-i5q3l2-mz.121-9.EA1c.bin using xmodem. afterthat, i typed boot and it boots into the image but when i reload the switch, i didn't work and w...
is your your telnet command configured correctly or your access-list perhaps ?or like what you say, it's a routing problem. so does your return traffic know where to go ?
HI, The ver7.0 has some improvement in terms of failover. Especially on the power failure of the primary unit. When talking about failover, i recommend 7.0. It also now supports IPsec failover. I got my unit with 6.3.4 and have upgraded it to 7.0. ...
Perhaps you should verify if the command "telnet 0 0 inside" is there and ping from a directly connected interface to the pix. If you still cannot, how about switching failover and test again.....
HI,For your first question, yes you should be able to ping and also to telnet to the secondary firewall. I have not test whether it will function like the primary if i actually redirect some of my traffic to it though.... For your second question, y...
