Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiBased on the data sheet of a 10GB SR port, there is a sentence that read: The launch power shall be the lesser of the class 1 safety limit or the maximum receive power. Class 1 laser requirements are defined by IEC 60825-1: 2001.So the question is...
HiI am doing a migation from alteon AD3 to Cisco content switching module (6500)On the alteon config, we saw the following:a) /c/slb/adv direct ena aphttp enab) metric minmissesQuestion:1) is there any guide available to migrate from alteon ad3 to ci...
Hi,I am using the router mode load balancing. I checked the documentation and found that the VIP (virtual serer IP) is always the IP address on the Client vlan. The only time i saw the VIP on the server LAN is when we are using Direct Access.My quest...
Hi,I have a router that is running EIGRP Stub routing. However, there is a need for me to connect a non-EIGRP (but ospf capable) capable router to this stub router. Is it possible for me to run OSPF process on this EIGRP stub router and redistrbute t...
hithe specs of 10GB SR says:The launch power shall be the lesser of the class 1 safety limit or the maximum receive power. Class 1 laser requirements are defined by IEC 60825-1: 2001. Yes the 10GB trasmit level is -1.2, but what is the class 1 safety...
HiDo not know if this is the problem for you but just take note that for 4 port E1 Pri card, you should use the second 9-16 connector instead of the 1-8 connector.Cheers
