Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a stack of 4 of these. SW1 & SW2 are displaying this message. 2 days ago & for weeks before I had no errors. This appeared 2 day ago. There have been no changes in the switches IP information, or any network changes upstream or downstream....
HiSetting up a new MX450 to replace a Fortigate. I need to allow 1 VLAN to talk to another VLAN only communicating on a specific set of ports & services. Fortinet allows to make service objects with the ports then assign to a service group. Then on...
Odd thing happened on Thursday. All of a sudden the guest WiFi clients could access my local network. Confirmed by 2 different devices from different locations. Then today when I go to test it's again being blocked. I disabled the guest WiFi once d...
We have a new Netmotion server set up. Everything is working fine expect when on the Meraki guest WIFI. I can get connected but can't pass data to the local network. I also cannot ping any local resources.Netmotion works fine on our corp WIFI using...
I have MR36 & 46 AP's. We are using Fortinet 426 switches that have the 2.5GB multigig ports. I tried to connect the 2 with a normal cat6 cable but the port speed stays at 1GB. Is there something I need to do on Meraki's side to turn this function...
Each remote office doesn't have the same subnet. However I need to pass the same subnet from the home office to each of the remote sites. Here's a pic & what I need to do....
Actually..scratch that! All good now. For some reason the IP assignement changed to static on those 2 switches instead of DHCP. It's all green now. Have to look at change log cause I didn't do that.Thanks
Bad IPv4 assignment configuration Yes it's all correct. It was not touched. The same IP information is correct on all 4 switches & nothing else is assigned to the MGMT VLAN I have set up. All 4 switches are using the same IP address as it's a logic...
Ok so I can do....Allow server to server TCP server1 6001, 80, 443 Server2 6001, 80, 443Allow server to server UDP server1 6001, 80, 443 Server2 6001, 80, 443??
