Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear allThere are 20 nodes which want to connect to eachother in fiber optic ring topology the issue is that service provider just with one pair core (only)the issue is I dont is this possib le weith regualt cisco switch or I should use CWDM ??please...
Hi , I implemented cisco nac 4.9 in our environment as OOB VG L2 with ADSSO integration ,before ADSSO was implemented everything had worked correctly , I have unauthenticated and access vlan that have diffrenet IP range , when I do not have ADSSO ...
hi ,I have implemented cisco nac solution in layer 2 Virtual Gateway out of band mode , but I have a problem with Remediation process ( I am using NAC agent),when clients are not compliant with my security policy , they move from unauthenticated role...
you know , we only have a single 2 core fiber and we should connect 20 node to eachother as a ring topology, it means a fiber must enter the switch and exit from the same switch, is it possible for switch to drop-and-insert fiber optic or not ?
yes of course , you must configure PORT GROUP on untrusted interface that is connected to switch port and put your Untrusted vlan number as an id there, after that restart your ESX and everything will work correctly.thanks for your attention,
Dear GugoMy problem was resolved , I implemented my CAS server on ESX which is caused the problem , I edited my ESX configuration and everything works fine,thanks
Hi Gugo ,Thank you for your reply,1. yes clients are in authenticated vlan (110) can get IP address configuration from vlan 50 subnet,(based on vlan mapping rule 110>50)2. Trusted and Untrusted interface of NAC server have the same IP , yes clients c...
Yes I checked it via monitoring>reporting , and it said that user successfully logged in temporary role, i created permit all on Local policy but the result is the same ,yesterday I changed the DG of my client to SVI and after that I defined the ARP ...
