Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have been programmming my own Python script to list EPG's, The Associated Subjects and Filters. If push this a bit more I could maybe write a connectivity check between two EPG's. Before I go down this road which will be painful (I am a Python no...
Hi AllI've cerated a baisc Ansible playbook that will create the following:- Tenent, VRF, App Profile, BD, BD Gateway Address, EPG, Contracts (Provider and Consumer for full mesh between EPG's), Conracts associate (prov/cons). It does this from aroun...
Hi AllNext week we are looking to move our Cisco 2801 CME phone switch to a new site. The new site will have the same amount of ISDN channels. We inherited this system allready configured and never had to do a lot to it. I've researched into setting ...
Hi AllI have a major problem at a suctomer site. I attended just to reset the password on their 2801 CME router. After reseting the password the phones will not come up, I've incuded as much detail as possible here as I am really up against it for ti...
Thanks Sergiu, this looking amazing. On a different planet to anything I could create. We are running ACI 4.2 and the python script is not in bootflash, has it been removed or moved somewhere else?
haha, I'm just wondering if there is any config to do on the interface but I guess not. Some poeple have suggested it will work without making any changes but that sounds too good to be true.
Hi CarloThanks so much, a power cycle on that remaining phone done the job. I'm a little converned about the interfaces being admin down on but never mind. Thanks.
The 7970 no longer has a DHCP binding. MAC address is 0007.0E16.5353pride-cme-cov_01#show ip dhcp bindBindings from all pools not associated with VRF:IP address Client-ID/ Lease expiration Type Hardware...
