Hey,I have a remote user at home that currently has a WRV210. The site to site vpn works fine on that one. However, the router has seems to be flaking out and some ports do not work and the wireless either.So I ordered him a RV110W. It has the latest...
we have a backup inet connection that i had an old netgear firewall on.A pix506e free'd up recently so i thought i would put that on the rogers cable connection as it was alot more stable than the netgear one i was using.I reset to factory defaults o...
Today for some reason the switch just crashed. using cisco Network Assistant see the following info.System MessagesDevice : Switch1 Severity,Timestamp,Event Description1-Alert,Mar 01 00:02:16,R4 = 0x00000009 R5 = 0x00000000 R6 = 0x00000000 R7 = ...
i have 6 3560G-24TS switches that will go into 2-3 seperate racks. They each have 4 SPF ports. What would be the best way to connect them all? i am not real familiar with spanning tree and whatnot so not sure best way to connect them without creating...
Hey,I have 2 x pix515e's to setup. This is for a colo so there are no workstations/users on the lan/secured int. However i do have sql servers that i would like to keep out of the dmz from the web servers. should i setup the pix with 3 interfaces: 1 ...
Luis,I had already looked at the admin guide. It does not have much in it.I disabled PFS on both sides (PFS on the WRV210 works fine) and the tunnel is more stable however his VIOP phone will still not work. He can hear me on it but I hear nothing fr...
ya i can ping the 105 gateway externally from another site as well.icmp is not enable on the 106 int.here is the capout when enabled and a ping is done.14:37:31.334592 arp who-has 208.97.118.105 tell 208.97.118.106on the asdm i dont see any traffic o...
well..left it off all night. powered up modem this am. then powered up pix.still no go.called rogers and they were not any help. they said they could ping it from outside, he reset it remotely. nothing worked.put the config into ciscos output interpr...
did a ping and show arp. it only shows internal ips, not the exteral with a mac.tried clearing arp and doing it again but still only shows internal ips in list.i will try leaving both units off overnight and cycle them up in the morning to see how th...
hey Mike,tried that earlier. tried it again just now. no luck though.i will try leaving both off for an extended period to make sure they are totally cleared out. see if that helps at all.any other suggestions?