Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Z3 gateway, and an MR33 access point.no matter what settings i put on the SSID of the MR33, my Epson SX535WD printer will not connect properly to the MR33. Yet if I set up an ssid with the same settings on the Z3 it works fine.all other clie...
I’m having issues extending wireless coverage of a Z3.i have wired in an MR33 and manually entered the same SSID name and settings as the Z3... however, my wireless printer (which can see both access points) does not seem to like this.I understand fr...
Have we STILL not got IPv6 support???? All I want to be able to do is VPN into my MX64 from a mobile phone, which unfortunately beyond my control is ipv6!The Error message I get whenever I attempt a client VPN connection:msg: unsupported ID type 5it...
I had already tried this, but it is the first initial connection to wireless that messes the brain of the Epson up, hence having to set the static IP up first on the printer before connecting.
It is all very strange, but I did manage to solve it.
i had to do a full reset on the printer, then before connecting to any wireless network, set the up address up manually, and then connect to the SSID of the MR33.
Cheers, yeah that was my thinking too. Seems a shame, as the Z3 seemed to do the “one box” trick, but am pretty disappointed with it to be honest, especially as far as the WiFi goes.... Band steering doesn’t work well, and I can’t even disable either...
