Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Originally posted to Application Networking Forum - Reposting Here:
--//--
Could someone give me a steer please.
I have a virtual F5 load balancer (VMM Domain is VMware). The VMM Domain is connected to my ACI and working for a number of VM's / ...
Hi,
I have read:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/kb/b_KB_Transit_Routing.htmlI have 2 x border leaf switches into which I have 2 x separate L3 out connections. Both are in the same VRF. Layer 3 Out one goes t...
I have a Cisco 4331 router that was configured with as a DHCP server for a small pool of Mitel iP Phones. The config of this router is a s follows:ip dhcp excluded-address 172.20.2.139 172.20.2.142!ip dhcp pool Voice network 172.20.2.128 255.255.255....
Is it possible to change the setting of the Attached Device Type (Fabric/Access Policies/Switch Policies) via the APIC from Bare Metal to ESX without deleting and re-creating the config on the ports the setting is applied to.
Many thanks.
Darren
Is it possible to change the install settings of the Anyconnect Client so it doesn't end up in the Startup Menu. We wish to automate the installation of the above across a few devices but don't want the client added to the startup automatically.
Rega...
Apologies for my delayed response to all those who replied. I haven’t been on the community forums for a while.
In the end we left the 887 providing the DHCP for the site in question. I’ll lab up the recommended changes above to see how things work...
Yes, sorry for the confusion. The vlan pool is set to dynamic but the vlan blocks are set static.
Under Fabric/Access Policies/VLAN, the pool is defined as 'dyanmic allocation; but the VLAN's within it (100-300) have the Allocation Mode set to Stat...
Thank you Manuel, this is great information.
My ACI setup needs some attention. The partner who helped me set it up didn't define dynamic VLAN's for the VMM Domain. We created a pool yes but it was statically defined so my server Admin and I have t...
Hi Carlo,
Thanks for your kind reply.
Long story short. My server Admin had some routes on the server which were incorrectly configured. We've since amended and now I can ping the device needed. Quite frustrating but nonetheless glad it's sorted....
