Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have created a new VLAN 120. I have created a DHCP server and have tagged the new SSID to vlan 120. From the MX to the APs, every port is trucking "All Vlans" with the native being 1. When I connected to the new SSID, I am not getting a DHCP addres...
I currently have 2 Vlans.VLAN 1 - with Internet access for our users.VLAN 20 - no Internet access. Everything on this VLAN is local for our AV gear. All the AV gear is using multicast. What would be the best way to give access to VLAN 20 from VLAN 1?...
Does any know how to block the Meraki status page for a guest SSID? If you connect to our guest network, you connect to the /16 Meraki provides. If you go to the gateway address 10.128.128.128, it pulls up the meraki status page and gives you what AP...
Yeah there are 3 MS225. Each uplink is a trunk port with native vlan 1 and allowed vlans all. The LAN firewall rule is set to allow. And yes the the SSID is configured just like that. Do I need to change instead of all vlans, set the allowed vlans to...
