Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a C9300x fiber switch and I am using SFP to ethernet adapters for our servers. The servers are connected to the network, but when I go to view the client on each switchport it doesnt show any client. No IP addresses, so I cant view traffic sta...
Does band steering move 2.4ghz clients to 5ghz even if the signal strength of the 2.4ghz is better?If thats the case, why would I ever want to use this feature?
I have VLAN 2, with ACLs that first permit traffic to our intranet IP, then deny the rest of the LAN.VLAN 2's DHCP server is set to Google.I wasn't expecting this to work, but I am able to go to the intranet website via its FQDN, but how would that e...
We have an MX105 concentrator for our sites, we were doing nessus scans and were getting results for RFC 1918 addresses that dont exist in any of our subnets (nor were they found on client list)...Looking at the nessus trace route for one of these bo...
I have an MX84.WAN 1 has IPv4 and IPv6 both are active. WAN 2 is IPv4 only (cellular backup).We were having intermittent packet loss on WAN 1 which would cause WAN 2 to take and give up the active roll over and over. So I changed WAN 2 to be the prim...
Do you have layer 7 firewall rules defined on those SSIDs? If so, have you tested an SSID without those firewall rules?wireless > firewall & traffic shaping
