Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear expert,I'm talking about the section under Work Centers > Device Administration > Device Admin Policy Sets. In our setup, the device is present under 2 distinct Network Device Groups. One time using a supernet /24 (management subnet) and one ti...
Dear community,I'm looking for ISE to remove sensitive information from the output of certain commands. For example, when issuing a show run command, I want to remove (or replace with *) all lines containing the word username and all lines containing...
Hi everyone,I'm looking to pick these up for a company with a growing network. I'm, however, confused about the SFP(+) ports. Ok, so there are 4 of them that can work at 10 gigabit speed simultaneously.What is the purpose of the 2 additional 5 gigabi...
Hello everybody,I've got a SLM 2008 smart switch. I've set the following options to switch port 1 which has the role of being a trunk port.1) Enable Tx force untag: disabled2) Ingress filter: disabled3) Acceptable frame type: tagged only4) PVID: 1All...
Could you please help me with following question. I've done my best to convey everything clearly, but if there are any doubts, please ask me to clarify.The manual says:When this option is enabled, all egress frames from this port become untagged. The...
It appears not to do this. It always goes to the same policy linked to the most specific IP. I can't find what's wrong so I decided to open a ticket with support!
Hi GeorgeI did find a way, I think. I'm going to test this next Wednesday. One can define an alias on the CPE and exclude items.for instance: alias Test show run | exclude password|user|etcThen you put config in ISE allowing a user to call only that ...
Dear Krishnan,Many thanks for your reply but I meant in it another context. Say I give access to a CPE to a third party. I want this 3rd party to be able to do a show run, but without seeing any sensitive information. Basically, I want to ISE to tran...
I took 25 minutes to type that haha. It is often hard to convery things about VLANs clearly.The main issue I had is that descriptions seldomly state the flow/direction of traffic. For the Tx force untagging I didn't now whether they meantA)device ---...
