I just activated multicast routing on a blank ASA and it warns with this message:WARNING: Interfaces part of explicit zone will not participate in multicast-routing Could somebody clarify why it appears and what cisco means with explicit zone? Thanks...
Hi, I have been going throug latest ASA release notes and I didn´t see that multicast is supported yet on ASA multiple context mode.
Anyone know if this is going to be supported in the future?
Thanks,
Miquel
Hello,
I would like to know how OSPF picks a path from two available with the same cost when maximum-paths 1 comand is applied.
An example using GNS3:
Before maximum-paths 1 command
R1#sh ip route 77.77.77.77Routing entry for 77.77.77.77/32 Known vi...
Hello,
I have 3 SFR modules on monitor-only mode within a virtualized ASAs registered on a Cisco Firepower Management Center for VMWare 6.0.1 . I can see normal traffic statistics on the dashboard but even I tuned signatures to generate IPS alerts fo...
Yeah, I though about it but then all VLANs go through the same link and my costumer wants one specific VLAN running over one inter-site link and all the rest over the other one.
I also though about costs + tracked static route for that specific VLAN ...
The thing is that in my real topology (attached) sometimes I'm having asymetric routing issues on R1 after one of the inter-site links (SW 1 or SW 2) fails and comes back.and I suspect that maximum-paths 1 is the responsible.
R2, R3, R4 and R5 are AS...
Well, the version command seems to help. At least I got a serial number.
Let's see if this is valid for the guy from cisco licensing. If not, I will go straight to Checkpoint product. I can't spend ages on this.
Thanks again Philip!