Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I want to have some discussions about the etherchannel with lacp enabled.From LACP protocol, an aggregation group binds the ports with the same speed, duplex and linkstate. Therefore, for ports with speed 100 and speed 1000 will belong to the...
Hi all,Can the port profile in nexus1kv be assigned to the specified uplink? For example, if I have two uplinks and one vm connect to the nexus1kv, and I want the traffic from this vm only go through one of the two uplinks, how can I configure that? ...
Hi guys,I have a question about mac ACL. It says that "MAC ACLs—The device applies MAC ACLs only to non-IP traffic.". So, what does non-IP traffic mean? Does mac acl can deny tcp traffic? I began netperf at first and then set the acl(deny such tcp so...
Hi all,I got a problem when I install nexus1kv on my esx host. The vsm is successfully connected to the vc, and the status is:acl-nexus(config)# show svs connectionsconnection vc: ip address: 10.117.8.38 remote port: 80 protocol: vmware-vim ...
Hi all,I know that we can run script with run-script command in nexus1kv. But how can I write the repeated command in the script? Does nexus1kv support the loop in the script, such as for or while? I can't find the material about it. Thanks in advanc...
Thanks, pkaretnikov.Etherchannel balances the traffic load across the links in a channel. So, in the above case, switch C can only load balance individually in channel group 1 or channel group 2. I wonder whether there is a technique that binds the p...
Hi Peter,Thanks for your reply!From your comments, I learn that etherchannel with lacp enabled can be configured on neigboring switches.Does it mean that the ports on different switches can be binded into a logic channel group? (such as ports on swit...
I use cisco switch 3560 and from its configuration guide for etherchannel it says:"When you configure one end of an EtherChannel in either PAgP or LACP mode, the system negotiates with the other end of the channel to determine which ports should beco...
Hi Swati,Thanks for your input!I know that the modes have no relations with the traffic. The traffic is determined by load balancing policies. I just want to comfirm the behaviors of LACP for cisco switch, the comments written in update#3. Thanks!Bes...
Hi Kevin,Thanks a lot for your comments!Sorry that I still have one confusion. I think an important feature of LACP is to automatically bind the ports with different capabilities to different aggregation groups. It means that it will automatically ad...
