Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, Recently we upgraded a crypto image for one of the 6509 series switch. Upon rebooting the switch to start with new IOS, the switch is throwing out the below message. And its not booting.,Autoboot executing command: "boot bootflac6k_sup2 ...
Hello all, I am unable to reset the password in our site's WLC 4404. I followed the steps given in the cisco document. Is there any other means by which i can reset the same. Note : Am able to SSH, HTTPS and take console of the WLC.Any help wil...
Hello, I am asked to configure a cisco ASA 5520 in routed mode. Can somebody shed some light on wat is the difference between configuring a asa in routed and transparent mode? Also a sample configuration for routed mode will be of great help...
Mahesh, I would suggest you check the configuration in DHCP server for the particular vlan, reason being there is no issues with switch end. IS the same vlan when configured in different switch is it working?RegardsRaja
HI, In that case, can u check if the reverse of this is working. i,e connect a pc to the router end(where printers are connected) and see if you can ping the PCs behind the switch.
Hello Surendra, The password has been recovered. We followed the same procedure, but the only addtional thing we did was removed the WLC from the network. Only then the password got reset. Also the WLC had been enabled with tacacas auth, which d...
