Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This post is related to my other posthttps://supportforums.cisco.com/message/3288869#3288869. I opened up a new post because the order of my replies is mixed up in the other postSummary of the problem: Certain devices in Ciscoview chassis view are re...
Some devices on my CiscoView do not show their chassis view. They give the following error message"Cannot find applicable device package for 10.x.x.x." (LMS 3.2, CV 6.1.9)I checked cv.log which gave me the following messageERROR CvDevice: CANNOT find...
I have 8 devices added to RME 4.3.1 (LMS 3.2), 3 devices are running telnet and their configs are backed up fine. However the other 5 devices are running SSH and when i do sync archive, I get this message..CM0151 PRIMARY STARTUP Config fetch failed f...
I am running LMS 3.2 with CiscoWorks Common Services 3.3.0. I recently added a new cisco switch WS-C2960S-48LPS-L and it promptly adds as "Unknown device type" with a question mark next to it. How can I get ciscoworks to recgonize the device type.I t...
How do I go about setting up LMS 3.2 to show syslog messages in the device center,I know my device is sending syslog messages out. Count and timestamp logging messages: disabled File logging: disabled Trap logging: level informational, 384946 m...
Just so its useful to somebody in the future, the problem was resolved was downloading and installing an additional file apart from the 2960 and 3560 device packages. The file was called dtshare and can be found under ciscoview shared device package ...
The order of my replies seems to be mixed up..Hi,You must have missed this from my original post. When I click 'check forupdates' after selecting cisco view, it is giving me a message 'no newupdates available for this product'I then went to CCO and m...
Hi,You must have missed this from my original post. When I click 'check forupdates' after selecting cisco view, it is giving me a message 'no newupdates available for this product'I then went to CCO and manually downloaded a file calledCat2960.cv50.v...
Actually. I have worked it out. Dont bother reply to above. I am currentlyinstalling latest 2960 and 3750 packages manually and I will let you knowhow I go
Hi,So if you are suggesting manual updates from the CCO, is there adocumentation that can explain me how I can go about it.If I am doing device updates for CiscoView, there are device package updatesand then there is shared device package updates. Wh...
