Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I set up a wireless network one years ago with one WLC ( model:2500 version:8.1.102.0) without any probleme. Since around two weeks, performance go down only for the wireless network which is a part of the local wired network (no vlan).
I...
Hello All,
I set up a tunnel IPSEC s2s between one ASA 5510 and a RV320.
The s2s is connected on both end but its not possible to ping a server on the otherside.
The tunnel was working good for two todays but now, even after a re-creation, still no...
Hi all,
I would like to modify the default MTU from 1500 to 1270 to avoid fragment on one of my VPN tunnel.
This tunnel is set up on vlan used by a lot of critical equipment.
Can i change the MTU for this tunnel specifically or have to do it on t...
Hello,It's possible to set a trunk on this switch ? apparetly it can manage vlan layer 1 and 2 but i still need a trunk. on WEB-GUI i did not found a option or feature to configure it.thanks in advance.
Hello,
Thanks for your answer...Ok, i'll try to find a console cable cisco to check log from AP.But, why this is not a good firmware ? do i need to perform an upgrade ?
UPDATE : log on AP in attached files Thanks,N.B
I dont have any log why the tunnel broke because is up on both side.
i initiated the connection from RV320 and ASA, each time the tunnel is UP but no traffic...
I dont have a lot of options on RV320 i can see the whole paket traffic for a port but ...
Hello Bogdan,
Thanks for your answer, i appreciate.
I already compare both configuration and they are exactly the same.
i checked log on RV320 all sound good as well
VPN Log | protocol/port in Phase 1 ID Payload is 17/0. accepted with port_flo...
