Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I was hoping someone could please help me with an automated script. The logic seems not so difficult although, I do not have much TCL experience...I need a way to load a list of IPs (probably 50 at a time), find their associated MAC address, th...
I've been reading the post here which is quite good but, I have some outstanding questions I hope someone can help me with? https://learningnetwork.cisco.com/thread/43100#233367 Essentially, we have a DCI which is an evpl link - layer 2. The evpl con...
Sorry - I was referring to the tunnel transport MTU. Are all your physical links in between the two tunnels based on 1500MTU? If so....You can first try using this on both sides under your tunnel interfaces (make sure that your physical interface is ...
Hello, My issue was due to MTU sizing not matching. EIGRP will try to use the highest MTU size supported on the link for sending it's routing table when neighbor adjacency is first brought up. If the MTU size is too large for the ANY link in between ...
Hello,Are you seeing routes being exchanged? I would try to run some more eigrp debugging to see at what point the adjacency goes down. I would also ensure your spanning tree is working properly and your route bridge is set correctly.The issue I had ...
The condition would be on a list of specific IP addresses. I have a list of IPs that need to be changed to a different VLAN, in which case we can reboot the machines and they will get a new DHCP IP. The vlan is going to be vlan 174 that it needs to b...
Thanks - I actually saw that response. Unfortunately my knowledge of this is just about nothing and am under a very tight deadline....I cannot seem to figure out how to add that logic in to change the port. It would be nice to ensure it isn't a trunk...
