Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to implement a VPN to the main office, but, they have a WatchGuard firewall wich I can not have access, and I have the phase1 and 2 parameters, everything seems normal, but I can not get access to the remote LAN, somebody has this experience h...
My LAN is growing, my first 254 IP's are using up, I need more available IP, my current LAN 192.168.0.0/24, solution, implement aditional networks, 192.168.1.0 /24 and on, managed them for a router which work like default gateway in order to comunica...
Hi folks,I have some routers instaled in remote office to main office, in the remote office i have that behavior: routers are working fine, but, if I move some of them or a cable conected to them or something similar, the router goes booting, if I ta...
Hi folks,My network is growing on, then, I made some diferent new networks, (192.168.0.0 LAN1-Current), (192.168.1.0 LAN2), etc, I want to manage these networks with a 1750 Cisco Router Fastethernet interface, but I notice I have a delay between LAN1...
Thax a lot for your comments Paul,you need to know that my diferent networks are connected to the same interface of 1750 router with secondary ip, in fact, it is the defaul gateway for all my networks.192.168.0.0 /24 200 devices192.168.1.0 /24 ...
Hi pnicolette,That configuration is in order to implement VLANs later,then, if I implement VLANs and I do not echange the router, will I get the same delay? or this router making trunking has a better performance?Thanx for your commentMartin
Thanx very much folks for your help,I do not know why Static and ACL is not working yet, but, nat 0 is working, then, I gonna install nat 0 config because I really need it, but I would like to know a nice document about this configuration, somebody k...
