Hello,I have 2 questions concerning OSPFv3 with Address-Family (RFC 6969/5838):1) Does the OSPFv3 IPv4 address family can establish directly a neighbour relationship with an OSPFv2 (IPv4) node (without redisbribution) ?2) Does the "old" OSPFv3 based ...
Hi,Is there a way to make a router sends RA only under certains conditions ?For example i would like a router to sends RA only if a specific SLA is true of if the uplink interface (WAN) is UP/UP, etc.Any ideas ?Regards,Martin
Hi,With LLQ+CBWFQ configured on an interface i can see tail packet drop using the command "Show policy-map interface X". I'm wondering why in cannot see the same information about these packets drop with the "show interfaces X" command ? Is the sho...
Thank you Nagendra,This is really interesting, i just realized that even using IPv4 Address family in OSPFv6, hello packet are still sent to an IPv6 multicast address...Regards,
Hello,I just read RFC 6204 about Basic Requirements for IPv6 Customer Edge Routers and it is explicity written:G-4: By default, an IPv6 CE router that has no default router(s) on its WAN interface MUST NOT advertise itself as an IPv6 default router o...
Thank you everyone,I agree with you stmillet, this is not a good practice and a routing protocol or HSRP should be used instead. This is not a real case but i was wondering if there is RA feature that i missed out that could do the trick. Ex: 2 int...
Thank you,The device is a 3400ME with version 12.2(25)SEG1The interface used is a gigabit interface with standard LLQ:policy-map LLQ_POLICY class PQ priority class CLASS_HIGH bandwidth remaining percent 50 class CLASS_MEDIUM bandwidth r...
