Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Please help with the solution. Below are the objectives.- I want to do two rate policing on my PE for client. (CIR = 512000, PIR = 102400)- On this traffic, I want to be able to do LLQ,CBWFQ,WRED e.t.c- I want this to be in output direction t...
Hi all,I am trying to assign bandwidth for two different clients using CBWFQ, I use a class map to call the address of each clients defined by an access-list. MY OBJECTIVE IS TO ASSIGN 128KBPS FOR EACH CUSTOMER WITH LEAST CONFIG BECAUSE OF RESOURSES!...
Hi All, I will like to ask quick question about DSCP marking and priority. I have a router and I am marking all mi traffic into five classes (EF,AF41, AF31,AF31,AF11) at the ingress interface. At the egress interface (with no egress policy) of same r...
Hi Expert,I have a small situation, I have a PSTN line (1234567) connected to my FXO port, and PLAR configured on it, so that when the 1234567 is dial from outside, it will automatically be routed to extension 111, it works prettly well, but my clien...
Hi Experts, Please help this voice issue. (Attached is the Diagram)I have two sites (site A and B) with two routers each (Router A and B). Site A has PBX extentions 2001 - 2003 and 1001 - 1004.2001- 2003 connected to the PBX is to be use locally at S...
Thanks,But as the ingress policy map marks the traffic as its coming into the router, at the exit interface, will EF go out before AF11 by default ( without egress policy map ), or an egress policy map needs to be applied at the output interface to m...
Thanks once again friend, I really appreciate.Like I said, the 4 FXO ports are connected to 4 lines from PBX, the lines had pre-configured on the PBX. 1001,1002,1003,1004There are phones connected to the PBX 2001,2002,2003,2004 Whats are the four PO...
Please pardon me, I have corrected the post below...Thanks once again friend, I really appreciate.Like I said, the 4 FXO ports are connected to 4 lines from PBX, the lines had pre-configured on the PBX. 1001,1002,1003,1004There are phones connected t...
Thanks once again friend, I really appreciate.Like I said, the 4 FXO ports are connected to 4 lines from PBX, the lines had pre-configured on the PBX. 2001, 2002, 2003, 2004Whats are the four POTS dial peers on site A router, that will make router ro...
Thanks for the reply, I so much appreciate. Below is ur configuration and my questiondial‐peer voice 5 voipdesc outbound call leg to SITE Bdestination‐pattern 100. incoming called-number 200. <<----- ( please whats the use of this and what is the...
