Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I wonder what would be the more elegant design/solution for one scenario where we have asa 9.1 with multiple sub-interfaces, one for each tenant, and internet on OUTSIDE that must be used for all tenants and with one DMZ interface that has shared...
Hi AllMy doubt is about the need of each switch connected to the VSS using L2 or L3 MEC to be ePagp trustable for Dual-Active Detection.If just one or two of my switches are configured with ePagp and are trustable for Dual-Active Detection, is this e...
Hi,I´m having an issue with ospf related to the fact that OSPF always prefer an INTRA-area route over an INTER-area.The point is that the INTER-area path is the optimal path couse it is 10G.There is any way, except put all elements on area 0, to solv...
Hi,The command "predictor hash address source" "Selects the server using a hash value based on the source IP address." but it is too vague.What it means? How can i determine at which server on serverfarm a client connection will be redirected for?I ...
Hi,There is any way to bring the block to the port fa0/24 of switch2.I´ve tried manipulating port cost and port priority without sucess and now i´m not sure that this is really possible.thanksRafaelgc
Sorry Reza but a have to disagree.Think about the loopback of this switch being advertised to the CORE-Router that is connected to DC.The CORE-Router will always preffer the INTRA-area route over the INTER-area, becouse of this, CORE-Router will alwa...
Reza,I understod what you said but this is not a definitive solution.Lets take the right side. Imagine the last switch in this section. To go to DC it will take the path along the 1G ring, not the path through the ABR and them the 10G ring.Got it?Raf...
Reza,There we go.Lets take sw-1 as an example.The traffic from CE connected to SW-1 goes through the 1G ring to reach resources on DC.I know why. I need a way to overcome this behavior.
Hi Reza Sharifi, thank you for your time.I already knew this rules, i need re-design this OSPF solution.Imagine two rings, one is 10G with 3 elements in area 0 and another is 1G with 60 elements in area 1.The 3 10G elements are ABR with area 1, it ...
Hi Sachinthanks for you awser. Very nice document.i´m already using predictor hash source to stick clients to real server in SLB.My doubt is about after the client ip address is hashed, which method is used to choose the real server. i understood fro...
