Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
Please refer attached exhibit topology
here i'm using 2way redistribution between EIGRP to OSPF .now i want my source ip 1.1.1.1 and 11.11.11.11 prefer path via S0/1(R2,R3) to reach destination 4.4.4.4 instead of S0/2 (R2 to R4) so is it...
Hello Fernando,you can do it with APIC.apic1# configure
apic1(config)# leaf 101
apic1(config-leaf)# interface ethernet 1/2-5apic1(config-leaf)# shutdown. Regards,Vishal
Hi Dan,Hope you are doing good! It seems that sandboxapicdc is down at the moment. Could you have a look at It's not accepting credentials Regards, Vishal Hathi
