Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i have one pix acting as hub and three pix as spoke. On one link i have pppoe on the outside interface. The ipsec tunnel get an MTU of 1492 while the other end at the spoke have an MTU of 1500 for this tunnel. Anyone who knows if there's a way ...
Hello,anyone who knows how to clear context (crashinformation) in Catalyst 6509 (Native IOS)SUP1A-2GE-MSFC2. I get some error messages when i do a "show stacks" and i think I have to clear the crashinfo.***********************************************...
I have a problem setting different mac-addresses on vlan interfaces in the MSFC. When i change the mac-adress on one vlan interface all vlan interfaces get the same mac. I have done this on some other 6509 with sup1 without any problems. This wouldn'...
Hello,have You checked the wavelength on both sides.On multimode it can be either 850 nm or 1310 nm and on SM 1310 nm or 1550 nm. I think that's the problem./Tony
Hello,I think there's a missing default route in Your 3226pointing at 192.168.1.1, the configuration of Your Pix looks OK. The reason why Vlan 1 can connect to internet is that by default there's proxy arp on the interface, thats why vlan 1 is ok. It...
Hello,i would suggest to remove access-list on the inside.You are only permitting udp and tcp, ping is icmp.It looks like it's alot of configuration in Your pix that have no meaning. I suggest You to do a write erase and only put ip-address,global,na...
