Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I have configured ft on ace 4710 for failover, but the failover is not working. Each ace is acting as active, whereas the peer status is showing " FSM_PEER_STATE_DOWN".I am ataching the configuartion file of both ace.Note: Physically I have...
Dear All,I want to filter traffic (tcp,ip,icmp etc) from one vlan segment to another vlan segment for particular ip address to ip address. I have done the following configuration, but I am not able to ping none of the ip address of valn 4 from other ...
Hi All,In network audit i have got the below mentioned comment from the auditor for cisco IPS 4270 device. but I am not getting any soluation for the same. Kindly help me out on this.SSL v1 Session key retrievalThe remote SSH daemon supports connec...
Dear Ameya,Thanks a lot for replying me. I have done the same configuration as per your suggestion but still same issue.Below are the changes made in the switch:access-list 102 deny ip host 10.179.126.19 host 10.179.124.11vlan access-map test1 10acti...
