Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently added a Cisco 1810 OEAP to my Cisco 2504 WLC and everything is working great except for the PoE port. I found in the configuration guide that the port is disabled by default and it includes a command to run but I could not run the command ...
I would like to configure a VPN tunnel from a remote site to my home office using a Cisco 2951 router. Will this require me to purchase the security license for my router? I noticed in the output of "show license feature" that it says "yes" under "Ri...
Hi. I have a Cisco 4507R+E and a 4510R+E that are both running IOS version 3.3.2XO. I am looking to update the IOS and all new versions appear to have E at the end instead of XO. For example, the recommended version is 3.6.5E. What is the difference ...
Thanks for the reply but I was actually looking to enable the PoE port on the Cisco 1810 OEAP. I finally found where to do so.
I had to check LAN Override in the Interfaces tab of the AP on the WLC.
