Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3750G stack that is running IP Services. I just introduced a 3750X into the stack.I checked the licensing on the 3750X and it says the IP Services license is only good for 8 weeks.What will happen to the 3750X in 8 weeks?Will it stop working...
If properly set up no real traffic should traverse the VSL. What amount is considered no real traffic? I see about 100 meg worth of traffic going from the 6500 with the standby route processor over to the 6500 with the active processor. There is no t...
Need some help determining what dictates how the packets are redirected (process or cef).I have a router with 2 ethernet interfaces. CEF is running on both of them. On one of the interfaces most of the packets are Processed redirected and another int...
I have a CSS 11503 running 8.20.3.03. I have performed a Nessus vulnerability scan against the CSS. The scans have shown vulnerabilities against SSH. It is reporting that we need to upgrade to OpenSSH version 5.0 or later.If I upgrade to 8.20.5.01 wi...
I have a OOB layout that has all the the switch ports controlled by the same profile. I would like to be able to place the thin clients on one network, the printers on another and say unix systems on a different one. Right now I have a filter that le...
The only thing connected to switch 2 in either VSS domain is the other 6500s and one other switch. The other switch is being used for dual-active detection. I attempted but had issues adding an image.The concern I have is if you sum up the input rate...
Daniel,I was just looking at a site that I have a 3845 set up pretty much the same way, except I have a DS3 on the WAN side.When I look at the WCCP on the 3845, they are all handled via cef.Any ideas on that?Here is the wccp info and interface config...
Daniel,Since the crypto map (which is needed) is forcing the need for the redirected packets being process addressed and not cef, I will not be able to cef all the packets. Which is fine since I now know the answer.Thanks for your help.
