Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe have the requirement to setup a public wifi access point for customers. To setup the public wifi network and ensure it is completely separated form our corporate network we have chosen to use a VRF at both the data center side and branch office ...
Hi All,I am wishing to deploy GET VPN to some segments of our private WAN (provider based MPLS).At the moment it would initially be deployed to four routers than expanding from there. The KS router which is hosted in our data center would be the keys...
HiIs it possible to deploy GET VPN to certain ip routes / routers within our WAN as some routers (older Cisco routers) do no support GET VPN and we are unable to upgrade those sites till late next Quarter.Half of the sites are supportive of GETVPN - ...
Hi,We currently have 3 sites using Alcatel OmniPCX PBX`s (SIP trunks between sites currently) + 1 sites using an legacy PBX all connected via WAN (All Cisco routers) from a central data center (2921 ISR w/ SECK9).What we are looking at doing is centr...
Thanks marwanshawi Just added the NAT as suggested by your post & sample config and this now works.And thanks for the reminder re the subnet routes on the branch office side.Much apperiated.
Ahh. Forgot NAT - however I should be able to get basic connetivity without NAT ?Also is setting up NAT in a VRF much diffrent to a standard NAT setup ?
Thanks marwanshawiJust tried changing the tunnel source to the actual Interfaces as mentioned with no luck.From each router I can ping either end of the tunnel OK. What is strange is that from the Branch Router I can ping the IP of FastEthernet0/1.90...
Hi Marwanshawi & Peter and thanks for the response.Mawanshawi is correct - we have the 202.xxx.xxx.xxx.xxx upstream in the VRF already.Below are a sh ip route vrf PublicNet from both routers;Branch OfficeGateway of last resort is 172.16.1.1 to networ...
Thought that would be the case. What other alternatives would you recommend to encrypt the traffic from each router allowing any-any communication.Luke
