Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have two 2921/K9 box which I want to run as active/standby and also I would like to run eBGP with my ISP and OSPF in LAN side. Do I need to buy DATA license? or is it fine with default image come with the box. Also want to implement QoS.
Hi,I have configured Tacacs+ on my cisco 2901 router. Its working fine. But I would like to configure in a way that AD will Take preference than local user even login from console.Could you please help me in this.Thanks,Goutam
Hi,I have installed a new cisco2901 router and configured the line vty 0 4 and console 0 and enable secret.But unfortunately I exit from the configuration and while going to login in again. I cannot login with username and password which is configur...
Hi All,I have to install and configure two 2901 routers at different location with high availability. These 2 routers would be connected through WAN, now I would like to configure high availability bwtween two routers.I have attached a small diagram...
Hi,We need to add a new IP range in the Network. In my network there are lot of Context in FWSM. Now to add a new network, I have created a new vlan and allowed to FWSM and same created in Context. but the vlan is not getting up in FWSM and Contex...
Hi,Router is configured with the following command lines.line vty 0 4login localpassword XXXXXline console 0login localpassword XXXXsavedas the login is configured with local so we need to creat a local user and password for this to log in. But by m...
Hi thanks for your suggestion but I am having very little knowledge on Router hardware...so I would like to know...there are 2 CF (CF 0 and CF1) card is there in Cisco 2901. which one i need to remove and if I remove is there any chance to crash the...
Hi,the document shows the process with ctrl+break option. but this command is not accepting by router through putty...i think there is a inbuild command in 2901 new router to denied this command.I have tried lot of times with break / pause option....
Hi I am using putty to login console...I dont have the terminal window in my laptop.I have tried to switch off the router but the password promt is not coming. Its going to the normal username and password promt. and if i put the username and pass...
